Roll forming Machine > Stud and Track Roll Forming Machine > How to rollform steel studs and tracks

How to rollform steel studs and tracks

Industrial roll former used to manufacture stud and trackOne of the most common uses for a roll forming machine is the manufacturing of steel studs and tracks.  Steel framing is commonly used in the commercial high-rise building and construction industry.  Lightweight and easy to assemble this alternative to standard wooden stick framing has gained popularity in the commercial sector.  So how are these common low cost parts manufactured.

7 steps to rollforming studs and tracks

There are 7 basic steps to foll forming studs and track.  Most industrial machines can manufacture all common sizes and profiles used for common drywall construction. The typical configuration for producing high volume parts includes 7 major systems.  Each performs a unique function through the forming process.  From preparation of the metal for bending to cut outs and holes needed for running wires and plumping on the job site.

1) Uncoiler

The uncoiler holds the master coil and feeds in to the line.  Alignment is critical here as any deviation will be amplified through the rolling process causing defects in the final product.

2) Flattener

The flattener add another step to pre-forming quality control.  Having a consistent material thickness as it feeds in to the rollformer is also critical to producing a high quality part.

3) Lubricator

The lubrication unit ensures the metal is easily bent as it passes through each roll stand.  Without this the metal would bind and rip apart as the rolls form the profile of the stud or track.

4) Pre-punch press

Pre-punching is a custom function and is where the holes and notches are made in the stud.  These are located in a common location to allow for wiring and plumping to easily pass through the studs.

5) Mill

The mill is where the forming action takes place.  The roll tooling bends and shapes the sheet metal in to the desired stud or track profile.

7) Cut-off press

The final steps is to cut off to the desired length either a stud or track.  Lengths can vary to fill an order size.

For more information see our stud and track rollforming machine lines.

 

Leave a Reply


Leadership

Manufacturing leading rollforming machinery for the steel fabrication industries around the world

Innovation

Developing new technologies and automation focused on delivering leading edge metal forming equipment

Design

Designing equipment to automate and process steel formed products more effectively and preciously